Engine Terminal is Now Awaiting Scenery

Still roofless, the roundhouse awaits final track testing. The pit for the coaling station is at left center. The short tracks on this side of the turntable are for MOW equipment storage, extra wheelsets, etc.

After the last few weeks, I have been working on the new Oakdale engine terminal. It has been a bit of bear to do that since there is very restricted room to work. To top that off, all the electrical has to be accessed by ducking under the railroad. When I was building the railroad, I left the fascia off until I was finished with wiring which made it an easy job. Now, the fascia is on the work area and it is not practical to remove it so I duck under.
   

Since the locomotives to be stored here will be primarily coal burners, cinders are produced and need to be dropped and carried away, hence the depressed ash pit track. In the background, Crown Flour becomes a new industrial site with probably another one to its right.

The trackwork went down easily enough except for the ashpit area which required the benchwork to be revised to accommodate the depressed track. Similar depressed areas were made for the coaling tower's coal dump.
   

Two curved turnouts allow locomotives into the yard. The box car in the background is sitting on the main line.

The power to each track is controlled by this
panel. This will help prevent overload of the
DCC system with several sound-equipped
engines all drawing current.

One of the side projects has been the complete replacement of light bulbs over the railroad. When I first installed the lighting in 2008-9, the best bulb available was the CFL but I always thought that the light was too yellow. Your eyes adjust to it but it wasn't right. I finally found a relatively low-cast LED 100W-equivalent bulb and unscrewed and rescrewed all 75+ bulbs with these 3000°K units. The railroad looks quite a bit better. My operating crews have not seen it yet but I like it.
      The coaling tower and sand house have both been constructed as has the yard office. Now I just have to get some scenery going so I can get this area finished.